Search
Now showing items 31-40 of 617
Energy ans exergy analysis of biomass co-firing in pulverized coal power generation
(2011-04-01)
Biomass co-firing with coal exhibits great potential for large scale utilization of biomass
energy in the near future. In the present work, energy and exergy analyses are carried out
for a co-firing based power generation ...
Design and development of an extended range electric bywire/wireless hybrid vehicle with a near wheel motor drivetrain
(2009-05-01)
With automobile propulsion energy sources turning away from petroleum, the evolution
of technology naturally lends itself to electrical hybrid vehicle architectures relying on
alternatives as a primary electrical energy ...
Design and development of an automated uranium pellet stacking system
(2009-06-01)
A novel design for an automated uranium pellet stacking system is presented. This
system is designed to replace the manual method for stacking uranium pellets for
CANDU fuel bundles that is currently used at Cameco Fuel ...
Energy, exergy and cost analyses of nuclear-based hydrogen production via thermochemical water decomposition using a copper-chlorine (Cu-CI) cycle
(2008-04-01)
In this thesis the Copper-Chlorine (Cu-CI) thermochemical cycle and its components as well as operational and environmental conditions are defined, and a comprehensive thermodynamic analysis of a Cu-CI thermochemical cycle, ...
Development of H∞ control strategy for a multi-wheeled combat vehicle
(2016-08-01)
A vehicle dynamics controller for an 8 x 8 heavy combat vehicle utilising both torque vectoring and third and fourth axle steering is propoed. The control scheme is composed of two controllers: a feedforward zero side slip ...
Analysis of hydrodynamic phenomena in a fluidized bed for thermochemical hydrogen production
(2008-04-01)
This thesis examines transport phenomena of cupric chloride (CuCI2) hydrolysis within a fluidized bed. Conversions of CuCi2 and steam as a fluidizing gas are numerically investigated using a new non-catalytic gas-solid ...
Modeling and vibration analysis of a rocking–mass gyroscope system
(2008-04-01)
Rocking-mass gyroscope consists of an assembly of four cantilever beams with a rigid mass attached to them in the middle subjected to base rotations. Due to the gyroscope effect, the beams undergo coupled flexural-torsional ...
Cooperative relay beamforming design for multi-cluster relay interference networks
(2016-08-01)
In this work, we consider a multi-cluster amplified-and-forward (AF) relay interference
network and design relay beam matrix for each cluster to maximize the minimum
signal-to-interference-and-noise ratio (SINR) at ...
Design optimization of active trailer differential braking systems for car-trailer combinations
(2016-01-01)
The thesis studies active trailer differential braking (ATDB) systems to improve the lateral stability of car-trailer (CT) combinations. CT combinations exhibit unique unstable motion modes, including jack-knifing, trailer ...
Monte-Carlo-simulation-based performance analysis of the heat transfer process in nuclear-based hydrogen production based on Cu-Cl Cycle.
(2014-08-01)
As a crucial step in nuclear-based hydrogen production based on Cu-Cl cycle, the performance analysis of heat transfer process is of paramount importance. However, as a newly built system, the major obstacle of applying ...