Search
Now showing items 11-20 of 33
Analysis and optimization of fuel cell based integrated powering systems for clean rail applications
(2019-08-01)
In this thesis, proposals of novel integrated fuel cell powering systems for cleaner railway applications are presented and analyzed thermodynamically. Both energy and exergy analyses are conducted on these systems for ...
Development of a new integrated sustainability assessment model for energy systems
(2017-07-01)
This thesis presents a novel and comprehensive sustainability assessment model for energy systems. The model features an integrated approach and encompasses various multi-disciplinary areas of study, which influence energy ...
Investigation of a hydrogen production process through aluminum and water chemical reaction
(2019-12-01)
This thesis reported a novel hydrogen production experimental set up, which utilized the chemical reaction between aluminum and water to produce hydrogen. The constructed experimental setup had an aluminum powder spraying ...
Performance investigation of various cold thermal energy storages
(2008-07-01)
This study deals with solidification and melting of some typical encapsulated ice thermal energy storage geometries. Using ANSYS GAMBIT and FLUENT 6.0 software, HTF fluid motion past encapsulated water (ice) geometries, ...
Development of a model to investigate the sustainability of Ontario’s future electricity supply through a dual life cycle lens
(2021-10-01)
Since the turn of the century, greenhouse gas emissions and their climate related impacts have been studied with increased vigor. A tool that has gained popularity in supporting the reduction of emissions is life cycle ...
Modeling, simulation, and design of hybrid EV-battery charger for optimum grid utilization
(2020-12-01)
The rapid recent development of electric vehicles (EVs) charging system, is changing the future of the transportation sector. Thanks to Photovoltaics solar energy (PV), the EV charging operating cost is reduced, and an ...
Investigation of drying conditions for dental practice loads
(2019-04-01)
This thesis investigates different drying techniques for dental practice loads experimentally and numerically. Several experiments are carried out by changing both top and bottom wall temperatures while changing the ranges ...
Design and implementation process for controls integration using CAN bus on a full function electric vehicle conversion
(2014-03-01)
From the electrical engineering perspective, this thesis addresses the design and
implementation of the conversion process from a hybrid electric to a full function electric
vehicle (FFEV). The architecture selection process ...
Thermodynamic performance assessment of three biomass-based hydrogen production systems
(2010-04-01)
Hydrogen is likely to be an important energy carrier in the future. It can be produced by the steam reforming of natural gas, coal gasification and water electrolysis among other processes. However current processes are ...
Experimental and theoretical investigations of a new integrated solar tower system for photocatalytic hydrogen and power production
(2013-08-01)
Solar energy conversion via photocatalytic hydrogen production from water is an attractive route for the propagation of a hydrogen economy. Increasing the efficiency of such systems to meet the target of 10% is essential ...