Search
Now showing items 21-30 of 118
Integration of deviation zone evaluation and point measurement planning in coordinate metrology
(2015-03-01)
Reliable inspection of a manufactured part with coordinate Metrology demands excessive time to provide higher accuracy. The uncertainty of inspection highly depends on the number and location of points acquired during the ...
Jointly optimal pre- and post-channel equalization and distributed beamforming in asynchronous bi-directional relay networks
(2015-09-01)
We consider an asynchronous two-way relay network, consisting of two transceivers and multiple relays, where due to the propagation delays of different transceiver-relay paths being different, inter-symbol- interference ...
Characterization of fluid flow in paper-based microfluidic devices
(2015-07-01)
Paper-based microfluidic devices are being leveraged for application of diagnostic and detection technology in low-resource settings. In order to design a highly accurate device, a mathematical model is required to predict ...
Spectrum sensing based on capon power spectral density estimation
(2015-04-01)
Cognitive radio (CR) technology has evolved to solve the spectrum scarcity problem and improve
spectrum utilization. Spectrum sensing is a CR function that allows secondary users to
efficiently utilize the spectrum without ...
Inspection & modelling of cusp geometry in additive manufacturing to predict product’s surface roughness
(2015-04-01)
The final dimensional and geometric inaccuracies, and the resulting high surface roughness of the products have been the major problems in employing Additive Manufacturing (AM) technologies. Most of commonly used Additive ...
Single-stage boost integrated asymmetrical half-bridge AC-DC power converter with dual modulation for indoor led lighting
(2015-04-01)
Light emitting diodes (LEDs) for indoor lighting is a promising technology which can lead to major energy saving and cost reductions. The major concerns of improving power factor and regulating the output current ripple ...
Design and development of an automated pellet inspection system for nuclear fuel pellets
(2015-04-01)
A prototype for inline, non-destructive inspection of uranium dioxide (UO2) fuel pellets
at production speeds of two pellets per second is presented. The system tests
the surface of each cylindrical ceramic pellet using ...
Determining the effectiveness of nuclear security through computer simulation
(2015-09-01)
There is a growing concern from both national regulators and the International
Atomic Energy Agency (IAEA) about the threat posed by attacks against iconic targets such as nuclear power plants. This has led to an increased ...
Study on supercritical fluids in an intermediate heat exchanger for an SCWR hydrogen cogeneration system
(2015-12-01)
SuperCritical Water-cooled Reactors (SCWRs) are one of six Generation-IV nuclear reactor concepts under development worldwide. SCWRs benefit from an increase in thermal efficiency due to the reactor coolant operating above ...
Monte Carlo simulations for the purpose of efficiency curve calibration for the Fastscan whole body counter
(2015-08-01)
In order to be able to qualify and quantify radiation exposure in terms of dose, a Fastscan whole body counter must be calibrated correctly. Current calibration methods do not take the full range of body types into ...